Atmel Wireless LAN Access Point Manuel d'utilisateur télécharger pdf (Page 73)

Using PING Command

This section describes how you can test if you are connected to the network.

1. Under MS-DOS (command prompt) type “ipconfig” to see your IP address.

Note: If your IP address is 0.0.0.0 then you have an invalid address. Proceed to

network configurations

section to set your IP.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 126 127

Pas de commentaire

Atmel Wireless LAN Access Point Manuel d'utilisateur Page 73