Atmel Wireless LAN Access Point Manuel d'utilisateur télécharger pdf (Page 23)

Wireless LAN Access Point Configuration

 Refresh

If you want to get the original setting on the Access Point, pull down the File

menu and select the Refresh submenu.

 IP Configuration

Pull down the Setup menu and select the IP Configuration from the Bridge

submenu. You can modify the IP Address and IP Mask through this window

directly. If DHCP is enabled, select the primary port where the DHCP server is

connected.

 Filtering Configuration

Pull down the Setup menu and select the Filtering from the Bridge submenu. If

IP Routing is enabled, only the IP protocol packets will pass through the WLAN

and any other protocols will be filtered out.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Pas de commentaire

Atmel Wireless LAN Access Point Manuel d'utilisateur Page 23